GE Measurement & Control SolutionsGE Measurement & Control

Banner
Banner
Banner
Home » Calibration Blocks
E-mail Print

Calibration Blocks

Offering

Calibration Blocks—European Standards

Block Type (Steel)Order CodeDescription
K1
EN 12223
59108
  • Large angle beam calibration block, 100 mm radius
  • Calibrate range with an angle beam transducer
  • Measure beam index point and refracted angle
K2
EN 27963/ISO 7963
50434
  • Small angle beam calibration block, 25 and 50 mm radii
  • Calibrate range with an angle beam transducer
  • Measure beam index point and refracted angle
VW 50441
  • Step block for calibrating thickness range
  • Eight .039 in (1 mm) steps, .039 in (1 mm) through .039 in (9 mm) to .315 in (8 mm)
N30 58474
  • Ultrasonic reference standard
  • Connect directly to flaw detector
  • Produces multiple echoes at precise intervals in steel
  • Check instrument gain over long time periods

Calibration Blocks—North American Standards

Block Type
(Steel)
Order CodeDescription
IIW Type 1 118-540-270
  • Large angle beam calibration block
  • 4.0 in (101.6 mm) radius for angle beam range calibration
  • Measure beam index point and refracted angle
  • Also used to check resolution and sensitivity
IIW Type 2
118-540-280
  • Same as IIW Type 1 with 2 in (50.8 mm) and 4 in (101.6 mm) radii for range calibration
  • Side drilled holes also added for resolution check
DSC 118-540-300
  • Small block for angle beam distance and sensitivity calibration
  • 1.0 in (25.4 mm) radius opposite a 3.0 in (76.2 mm) radius
  • 0.375 in (9.5 mm) slot in the 3.0 in (76.2 mm) radius
  • Also used to check beam index point and refracted angle
Angle Beam,
Miniature
118-540-260
  • Substitute for DSC block
  • 1.0 in (25.4 mm) radius opposite a 2.0 in (50.8 mm) radius
  • Side drilled hole to check beam index point and refracted angle
AWS
Resolution
118-540-350
  • Evaluate angle beam transducer resolution capability
  • Three sets of side drilled holes for 45°, 60° and 70° angles
  • Three 0.062 in (1.6 mm) diameter holes in each set of holes
NAVSHIPS Test
Block
118-540-370
  • For NAVSHIPS specification 0900-006-3010, Section 6
  • Distance amplitude correction, sensitivity, and flaw depth
4-Step Block 118-540-320
  • Step block for calibrating thickness range
  • Steps .250, .500, .750, 1.00 in (6.35, 12.70, 19.05, 25.40 mm)
5-Step Block 118-540-310
  • Step block for calibrating thickness range
  • Steps .100, .200, .300, .400, .500 in (2.54, 5.08, 7.62, 10.06, 12.70 mm)

Download

Descriptions English Français Deutsch 日本語
Transducer Catalog acrobat-reader acrobat-reader acrobat-reader acrobat-reader


acrobat-reader